Flowers from plaster with candles is amazing handmade, which will give the interior of your house or apartment unusual and fabulous appearance.

In the art of such material as gypsum, has always been very unexpected and original. To do him some beautiful work with their hands was not always easy or it happened as often as not, for example, paints, wood, metal, etc.

FLOWERS FROM PLASTER  (3) Materials that will be useful to make flowers from plaster with candles FLOWERS FROM PLASTER  (4) Artificial flowers;
Gypsum powder;
Wide Cup or something in the same form;
Smooth glossy paper;
Candles flat, in the form of a washer;
Small gum;
Hot glue gun
Varnish, paint, sand sparkles (optional).*

FLOWERS FROM PLASTER  (5) Let me just say a few words about artificial colors. In this work, a suitable artificial flowers of almost any kind. But, as for me, the best flowers with large hard petals. Simply, more soft and delicate petals will stick together among themselves and form something like a lump of plaster.

Now let’s prepare the flowers. The first thing to do is to release the center of the flower for a candle. Tear off a bit of the petals from the center. And then pokupaite there (in the middle) little hot glue to make the rest of the petals is not broken up or that is not excluded. Next, cut the stems as the flowers will lie on a straight surface, and the stem that will be in the way.

Once the flowers are ready, begin the manufacture of a plaster solution. Because the period of time for making all the work is short, as the plaster dries quickly, need to consider all the items to place in front of him and do everything at a rapid pace. Moreover, if the colors bude considerable amount. In the manufacture of a plaster solution stick to the instructions, which necessarily is on every package.

Note! When you make a solution, then add a little more water than specified in the instructions on the package. Already checked, it will be much better. In consequence, the solution is to get a little thinner, allowing better to cover the entire flower and each petal plaster.

FLOWERS FROM PLASTER  (6) Now proceed to the most important. Get ready to bypacket their hands. Or you can wear gloves. Rent and immerse the whole head of a flower in a plaster solution so that he got into all the cracks flower and cover the whole outer part. After, remove the flower from the solution and a little shake to get rid of excess plaster solution. Only do it inside the tank, so as not to abspath. Then carefully inspect the flower, in order to ensure that he is fully covered with gypsum. If there probely, enclosure, apply, causing the plaster with your fingers, or dip the flower again and don’t forget to shake. FLOWERS FROM PLASTER  (7) After everything was put flower of plaster on a hard flat surface, pre-laid paper. This is to ensure that the base of the flower was smooth and flat. And immediately, while not cured plaster, put in the center of the flower round flat candle. So we avoid the situation where designated candles may not be enough, and the petals of the flower have become stiff and immobile. FLOWERS FROM PLASTER  (8) And the little rubber bands are used in cases when you need to fix the candle petals, which are located in the center of the flower. FLOWERS FROM PLASTER  (9) Now You have to wait for such wonderful colors of plaster is completely dry and light candles.

FLOWERS FROM PLASTER  (1) However, great job? I think You liked it. This original work will serve as a wonderful gift for friends and relatives, or simply will be the original interior decoration.


You can leave a response, or trackback from your own site.

Leave a Reply

счетчик для сайта